Engine Drivetrain 2nd Gen S N14 JCW OEM Air Box cone filter on N18 engine

Discussion in 'Tuning and Performance' started by JCWorx, Aug 22, 2013.

  1. JCWorx

    JCWorx New Member

    Jun 9, 2011
    15
    10
    0
    Deepwater Offshore Designer
    Texas
    Ratings:
    +10 / 0 / -0
    As far as the mounting screws not lining up when adding an N14 airbox upper housing to an N18 lower housing, has anyone replaced the bottom airbox housing (on an N18) with the N14 housing then added the "old" cone style gen2 JCW airbox.... I was told this works and has been done at WMW. I'm about the pull the pulg on both a JCW intake (JCW AI PN: 13720429380) and the whole Intake muffler assembily housing (Intake Muffler PN: 13717577509) and see if it will fit on the N18 (Gen2 GP).... I have to get the whole stock N14 Air Intake to get the bottom housing part of the N14.... unless I find a used one....
    Any input or pictures would be great....

    This will be done on a Gen2 GP
    Thanks
     
  2. rckrzy1

    rckrzy1 Member

    Jul 14, 2015
    34
    11
    8
    Ratings:
    +11 / 0 / -0
    I just bought the ECS CF intake, the darn cost of the upper and lower, as you need n14 Lower and JCW N18 upper exceeded the $499 cost of the very bling bling ECS all carbon intake. BTW it works great, gained torque back lost to open air intake and still gained HP over stock, very nice setup.
     

Share This Page