I got a set of new-to-me wheels last fall that were missing center caps. After a bit of looking, I found a set of electric panel knockout seals that were the correct size. Added a bit of paint, some stickers I had laying around and a few coats of clear-coat to make a set of custom caps.. Hope to get the wheels back on the car in a couple weeks, and I'll add another pic then..
Wish I could remember.. I've had them tucked away for many years in my MINI "junk" pile of stuff I've collected.. May have been from a MINIUSA thing. Finally have the perfect use for them.
Cool, They look good, how did you attach them? I can't find two of mine, I used duck tape till I find em.
There are 8 little "finger" tabs on the back along the perimeter.. just needed to bend them out a touch for a tight pressure fit
Where did you get the caps? I need to have all four of mine done too. But i dont want to pay the money for the ones through Mini USA.
I got them at Menards in the electrical section (by the conduit, junction boxes, etc).. They were only a couple bucks for a package of 2. My wheels use larger sized caps than stock wheels, so hopefully you can find something that is the right size for you.