Separate names with a comma.
I bought these from Texas Speed Works and they will convert a first gen (02-06) MINI's lug bolts to lug nuts. These are great for track use when...
I just removed this exhaust from my 2006 MCS. The car has only 51K miles on it so the complete exhaust system is in really nice shape. Includes...
Pulled off a 05 MCS -- went back to OEM. ~12k on it. Comes with 4 bolts at the proper length to mount using rubber grommets off OEM bolts. You...
Got a used 10k ish mile heat exchanger 40$ shipped. Cleaned and ready to ship. And 2 Akata 12mm(just under half inch) wheel spacers 4x100 56.1 hub...
I just installed the TSW X Brace on my R53. I was questioning if anyone used additional washers or just used the original bolts and tightened...
Do studs get rid of the need for hub centric rings? This is my first vehicle with bolts and as far as I know, this hub centric deal only affects...
Since I live in part of the country that doesn't feel the need to throw food seasoning onto the roads when it gets cold, my 14 year old MINI does...
I'm fitting a set of Konig Crosshairs to the MINI. The factory bolts, though small aren't small enough to fit into the bolt/lug holes on the...
This may seem like an "off the wall" question, but can the bolts holding the inner ball joint to the sub-frame be installed upside down? On...
Way Motor Works just got the new complete Titanium Bolt kits for the R52 and R53 Cooper ATI Super Damper Crank Pulleys. This is the first time...
New R50 MINI Cooper JCW cylinder head core with head gasket and head bolt set. $1250 Contact me at [email protected] for info and photos....
Trying to take the "dogbone" motor mount off my R53 and those bolts will not budge at all with just elbow grease alone. I dont want to strip them...
So I just bought my '03 r53.........clutch went out :( replaced it.... however other problems have cropped up. Normally I would have taken the...
Well, I think the title was quite descriptive. Anyone with any ideas on where to find these? Thanks..........
Anybody have a set laying around they want to get rid of? Bryan
