Separate names with a comma.
OE Front Camber Adjustment/Nylon Stud Removal by Keith (aka k-huevo) These cars need more negative front camber for anything other than...
k-huevo submitted a new Article: Replace Strut Springs Read more about this article here...
How To: Replace Strut Springs by Keith (aka k-huevo) Tools Needed: 13mm, 16mm, 18mm, and 21mm standard sockets; 21mm strut socket BMW # 31 2...
k-huevo submitted a new Article: R53 Thermostat & Housing Installation Coolant leaking from the thermostat housing is a common problem. Most...
Coolant leaking from the thermostat housing is a common problem. Most often it is the gasket around the coolant thermostat that has lost its seal....
While in gear, place a screw driver in a brake rotor vein on both front wheels, and brace against the brake caliper. This will provide the...
Not close to you, but may be worth calling Chad at BMW Repair by Total MINI & BMW Services in North Charleston, SC | Bimmershops.com
There are many possible reasons the OP's oil light comes on at idle. I mentioned the filter because (1) past correlations of light at idle & oil...
Unfortunately, when the light comes on the damage has been done. Was an aftermarket oil filter installed when the oil was changed? If so, or...
Thermostat housing.
Yes
High Pressure Fuel Pump
I've not had favorable experience with FSD struts for whatever that's worth. For strut bodies causing a tight fit, there is an OEM tool for...
1/4 inch drive extension on left, BMW spreading tool on right.
For struts causing a tight fit in the steering knuckle, insert a 1/4 inch drive extension into the pinch gap and turn 90 degrees to increase...
Become familiar with accessing the valve because it will require lubrication maintenance, and an occasional twist of the cap lock ring.
How many nipples does your Forge unit have? If only one, return for an upgrade. Remove the end cap and make sure the O-ring is intact and where...
That's a T-MAP code generated in the intake manifold. Could be a faulty sensor, tune related, or obstruction. It is not a lean condition.
Just an FYI about the MINI fuel pump. An adequate fuel level within the pump housing is maintained regardless of the tank's fuel level; except...
The crank journals on the R53 are significantly larger than the R50. R53 connecting rods will not fit the R50 crankshaft. Nathan's issues...