Separate names with a comma.
Don't you hate it when that happens :-p Scared a few corner workers myself with a faulted-out ABS. For the life of me, I can't understand...
Have you double checked the bolt that attaches the yoke to the shaft? If that's sheared off internally, it might cause this problem. Jason
I'm curious what fails on them? Jason
That seems "normal" to me for 215/45/17 tires. Even with stock springs, I found that I'd get ever so slight rubbing at full compression with the...
I use the Speedbleeder SB1010S-SS (stainless) M10 x 1.0 x 31.35 on my R53, they seem to work just fine for me. I originally tried the Russell...
Brand new VDO fuel pump installed over the weekend. Problem solved, case closed! Jason
I understand what you are saying; but I'm trying to determine the source in this change in behavior of my car. In the first 190,000 miles or so,...
I'm not sure how this would cause a leakdown of fuel pressure?
Just a quick follow up: I went ahead and replaced the filter - paying very close attention to the o-rings. All of the o-rings were in place and...
Dear Nancy, Please don't scare me like that, at first I thought you were canceling for yourself! Jason
If it was a filthy filter, wouldn't I be also experiencing problems at high RPM/ high load situations? Other than startup, it sure doesn't feel...
nkfry, That's interesting and easy to check as I have a brand new filter/seals on the shelf. This current filter has been installed for 2 or 3...
Ok, I was basing it off of a VDO replacement for $195. Jason
Thanks for the info guys! I don't think I'd have any need for an uprated pump at my moderate power level, but thanks for the link. I did...
I've noticed that it's taking more cranking to start (06 R53, 196k miles) my car when I'm below 1/4 tank of fuel. Otherwise it runs beautifully,...
I find that this method works great for these situation: *Unbolt slave cylinder from transmission (leave fluid line connected) *Hold slave...
I'd also look into the toe-in setting. Too much toe in (even if it's "within spec") sure can cause wear issues on the rear. Zero rear toe or...
+1 on the 15x9's up front. They fit on my setup (stock brakes) with only a 1/4" spacer. They work great with a 225/45/15 and actually work...
Sounds like you can't go wrong with the Valeo. While you have the trans removed for the install, I'd strongly recommend taking a little extra...
One other possible source of noise when your foot is off the clutch would be a problem with the input shaft bearing in the transmission. That is...