Separate names with a comma.
My family mechanic had reservations about installing an OBX header because of removal of the pre-cat. Who around Pgh will do an OBX install...
never mind, the part number posted above is for the standard injector....
Ok some updated information Link to information about fuel injector sizing....
Fuel injectors are rated on the pressure over the manifold. So the pressure that the injectors sees is the fuel rail pressure minus the...
BlwnAway, that would be 46-47 psi fuel pressure. I remember reading somewhere the stock fuel pump has trouble keeping 50psi fuel pressure...
What boot are you seeing at WOT? The fuel pressure would be the gauge minus the boost. -Jonathan
i figured ti would use the jcw210 flash with the larger injectors. It is inexpensive and gives mild gains. This was the injector i was looking...
If i did it I would source them from a bosh racing supplier and not ebay. Of course the JCW would be easiest. I simply wanted to know if...
Has any one tried Bosch 34lb/hr @ 3bar injectors? Based on all the calculations i could find they would flow at about ~380cc at 3.5bar fuel...
[IMG] The Jaffster shift knob, it is about even with the top of the radio. [IMG] The brass brushing i installed to remove the lateral...
I got a jaffster shift knob from bimmerworld with a helix short shifter and made an new brass brushing for the lateral movement (the taller...
when removing my exhaust for some clamp replacement i managed to quite easily shear off one of the studs that comes through the trunk floor for...
Thanks guys. I think i will give it a shot -Jonathan
Does anyone in the states still sell ported throttle bodies? I know M7 and Helix used to. I was pondering one for better throttle response on a...
is that dyno before and after tune? Do you have any baselines or impressions of where the gains in the powerband were? -Jonathan
Update, mission accomplished. I had a burr that had the pulley going on a bit crooked or vise verse. I cleaned up the galling on the crank and...
Thanks everyone for the advice. huervo, whenever i would try to turn the bolt the crank turns a little less then an 1/8 of a turn and will...
agranger i was following your instruction they were / are very helpful, thanks. ill try dropping the driver side of the car as i have all 4...