Cleaning black wheel well body molding

Black Wow, best stuff ever, and you can buy it from the inventor himself, here
ShowCarDetailing.com

 

Use Pre Wow, followed by Black Wow. Best stuff I have used on the plastic cladding.

 

Yes, for the full Wow, use Pre-Wow also. It is a cleaner/prep for Black Wow which is a dressing. A lot of us used peanut butter back in the day, but there was always a pack of dogs chasing you around:lol:

 

:cornut: THREADJACK-that reminds me of back in the day when girls used sugar water to curl their hair and bees would follow them around.

NOW BACK TO THE THREAD

Jason

 

"Black Wow Man!"

and beer..... :beer

 

Tomorrow going to wash, Hydro seal, Black Wow, both MINIs, with beer:beer

 

Just like everyone above I only use PRE WOW & BLACK WOW.

Clean off dirt and crap with soap and water.

Next Pre WOW away any old wax and other crud. Make sure pre wow is completely dry then apply the one and only BLACK WOW.

* note * If its your first time make sure you rub it in real well and leave a little film as it will be absorbed into the plastic overnight.

The next day run over your trim again with a dry "junk" MF towel to take off any extra BW and you will be good to go for a long time.

Enjoy the detailing (Pandoras box) you just opened.:lol:

 

Don't forget to wipe down all the suspension hardware too.

 

Well I do that when I take off the wheels to clean the insides. :lol:

Not every week.:ihih: