Separate names with a comma.
Make sure to put some sort of grommet around the hole for the adjusters or they will get worn right through.
Careful running too low of a spring rate. With a coilover you are reducing the amount of suspension travel you have available. Running too soft of...
The motion ratio is different in the front and rear.
I don't believe you will really be able to do anything to get that same feeling you got with the GP2. The most comfortable full setup is going...
Looking at a parts diagram makes me think that it is just another bolt into the front subframe. I didn't realize that it bolted to the frame rail...
Curiosity has the better of me. I'm removing my TSW Engine damper (The hydraulic damper not the big urethane thing) and trying to figure out...
Thank you Mr. Jim
Well obviously I did not have an issue with the lack of instructions. I did not ask for instructions. I asked about the requirement of modifying...
For anyone who has installed the Vibra-Technics lower mount for 05-06 MCS - did it require any modifications? I removed my BSH mount this...
Thanks for the information. Can you tell us the cost or PM me the cost? Thanks.
Looks nice! Is it the same splitter that Group4 is selling? It looks like you need to cut notches out in the bumper cover for the brackets...
Thank you very much for answering both points! I'll see if my local MINI technician can help with that.
I just replaced my R53 passenger side lower cushion due to the occupancy sensor going out. The factory replacement seat had the occupancy wire up...
