Separate names with a comma.
So I cut out the door step and now I'm trying to figure out what sequence to do the repairs.....I'm also trying to decide if it's a better...
Been working/thinking/planning on the q panel work, first I had to cut another 2" of metal out above where the patch will go as it's too rusty to...
Had to go buy an end for the extension cable, but Home Depot had one. So I gave it a try..... After welding these two together I could not drive...
Next project - try this bad boy out! 220V Miller spot welder. [ATTACH] Several issues..... 1st, it's heavy as hell, 30 lbs is my guess....
Today I went ahead and welded on the valance panel, then trimmed off the excess. I also put a few tacks in where the panel meets the inner...
So, looking at the Sport Pak arches, I went ahead and bolted on one wheel, and took out the brackets and installed the rear shocks, so I could...
So, after making the rear brackets and marking where the holes should go on the rear valance, I dropped it out and welded in some flange nuts. I...
Work plods along, today I built the corner lower brackets for the subframe. I bought some flanged nuts to weld into the sheet metal so I can...
Someone with a lathe and a mill could have done a better job, but it came out OK.....:cool:
[ATTACH] Last year just before we went to Rushmore and MMEMW, I bought a nice new MiniSpares dipstick, with a T handle and a couple of O-rings...
So far yet to go! I also made some short brackets to tie the inner wheel wells to a vertical brace to further strengthen the side of the...
Still don't have the parts for my air punch,, tho they show them shipped out via USPS on March 27th...... Today I cut a chunk out of the old back...
Today I'm grinding all the nubs off from my welds, it takes a while as I want to be careful not to damage the adjoining panel or grind thru the...
Surprise! Today I got a note from MiniTec that my axles are on their way to me......they even sent a tracking number. I have been working on the...
I've been going slow on this project, mostly because I don't really know what I'm doing! [IMG] Also, I don't want to weld something up only to...