Separate names with a comma.
I would pull the timing chain cover and check/reset the timing. Since the motor has been run the timing marks on the chain will not line up with...
If you kept the chain on the sprocket the whole time then you should be properly timed. The only way I know how to check this is to pull the...
Yes, the ATI damper says right on the front label that recommended rebuild is every 5 years. It uses rubber components that will degrade over...
I did the timing chain because new guides and tensioner only temporarily fixed the chain noise. I did not replace the old sprockets and...
Those 16 plug looking things are new valve seal, you'll want to get those to your machine shop if they are reinstalling the valves and springs....
It isn't a hard job to do. This is a pretty good video of what you'll have to do to pull the head and put is back on. [MEDIA]
If the new coil and wires does not solve the problem, do a compression test. Low compression in that cylinder will cause a misfire and that in...
If 6 was 9 [MEDIA]
G-LOC
You knew it was going to be some stupid little thing that you'd never envision being a problem.
Ren and Stimpy
buy
social security
soccer
Hells Bells