Separate names with a comma.
i have to replace 6 of them, and they arent the main reason im going in there, im putting in my new Giken lsd, along with replacing a coolant...
i found out they are 20mm...actually 19.5...but the bolts that are in are wayyyyyy too weak the only reason i put them in because i had no other...
ive reached out to valeo three times, and way motor works....i do have the ones that came with it, but they are on it..i need the bolts before i...
Does anyone know the length of the flywheel bolts that come with the Valeo single mass flywheel conversion for the R53? Ive reached out to WMW and...
its not the wheel liners ive run it without those and it was still there, the sound doesnt sound like the exhaust rubbing it distinctly sounds...
A while ago I needed to replace my crank pulley, however it was seized in the shaft, 3 people, 5 different bolts to go in the hole and 3 pullers...
So I set it with the cam mark pointing vertical and lines the marks up, they are going in the correct order and the cylinders are going down when...
No I mistook the line engraved into the cam sprocket as the timing mark rather than the triangle, an yes I rotated both, and I did go to the...
Yeah I usually deal with way, nothing against the or there's just that's who's been helping, and I emailed them yesterday no response yet How...
I recently replaced the timing guide and tensioner arm on my 06 R53, the guide had chunks out of it and pieces down in the oil pan, not fun. But...
i just drove it, going from my mothers Impreza sport, and my dads 4cyl. Tacoma, i re discovered the joys of life!!! lol but yeah it engages low...
I just finished my clutch job, when u kundalini the destroyed pressure plate and fly wheel, I decided to return the master cylinder u had bought...