Separate names with a comma.
Yeah, mine will definetly drag the ground if I lowered them all the way. Good luck. Colin will make it right, I am sure.
If you watched ModMini's video on you tube it isn't bad. Be prepared for the "one bolt" just to the rear and below the thermostat. Almost no tool...
It went about as well as I expected. Glad it is done. I only managed to damage one thing, the shifter cable bracket exploded while i fumbled with...
Well, I managed to source a Quaife LSD and pulled the transmission, replaced the clutch and flywheel, cracked open the gearbox and installed the...
Thanks Beken, I have gone with the Valeo.
Thanks Savvy I will check this out.
So, it is clutch time. I have decided to replace the clutch with the Valeo kit, instead of a stock setup. The prevailing opinion on the interwebs...
I would just like to send a public shout out to Colin at https://www.greeneperformance.com/. I installed the BC Racing coilovers that he custom...
+1 on the slave not engaging the clutch.
You might also replace the crank position sensor o-ring as it will be exposed once you get into front end service mode and have the radiator out...
So I was following your move to coilovers, and we had gotten as far as drilling holes for the rear adjustment cables. I have not seen any other...
Shiny.....
Looks great! Its been a while since I have been able to log on. You have come a long way and it looks amazing.