Separate names with a comma.
Everything's buttoned up and ready to go.....I re-torqued the head and reset the valve clearances, now all I need to do is have the alignment...
I think you can buy it in squeeze tubes or short caulk gun type tubes too, and it's way less expensive......
OK, no drips this morning, so I finished putting the radiator in and fired it up. I ran it for about 20 minutes till it was fully warmed up and...
So today I pulled the radiator and set up my new HF engine support bar so I could pull the motor mount off and get the cover out. It's a bit of a...
Sheesh, I have never had this much trouble keeping oil in a car before! I came back from my test drive and parked outside the garage and left it...
All righty then......took it for a spin around the neighborhood today, seems to run nicely although I didn't push it at all. Driving down a main...
Yep, all I have to do is bleed the brakes - I ran out of brake fluid so I'll run down and get some this morning. Driving it will have to wait a...
Got the shifter bolted back in and the exhaust installed. With the bottom end all finished I went back to the top - got almost everything buttoned...
I had intended to simply bolt this back in the car, but it was so grotty and stiff feeling that I decided to clean it up before putting it back...
Motor is back in the car.....only about 1000 things to hook back up and I can drive it again! [ATTACH] This is the new switch arrangement with...
Mine did that on my trip to Texas, AZ and Santa Fe last month.....I have a pic somewhere.... Edit: Found it..... [ATTACH]
CMU event starting in Wytheville, Va. I think the last one I did was there too, in 2018? In 2019 we went to Aspen for MMW.... Classic Minis...
My Mini is taking a trip to Va and NC next month!
Well, 6 hours later and not a drop. If it's still clean in the AM it's going back in the car! :cool:
So there was no joy in Mudville, a couple of hours after I finished I found a big green oil stain on the paper towel, the only good news is that...
The oil leaks were annoying me so much I decided to pull the motor back out and see if I can fix them. I used new gaskets and sealer (on one side)...
So, I got the choke cable in finally.....and maybe cured yet another dash rattle! Whohoo! Turns out the little bracket that was loose and...
After being gone for 2 weeks or more I was expecting a pretty good puddle under the green Mini but it was only a couple of small spots....so I've...