Search Results

Ordered the part through Amazon so it would be on my door step once I got back to town. Finally had a chance to get to it yesterday and it...

I think I am just going to order a new one so it’s here when I get back for install. Thanks MCS02 and 00Mini for the help. Sent from my iPhone...

Ok I tried eliminating the switch. I say tried because I didn’t want to run a jumper on the connector without knowing if it was going to cause...

Thanks for the link, I’ll have to get on this this afternoon. Sent from my iPhone using Tapatalk

If this was the case I assume a repair shop would be in order. Sent from my iPhone using Tapatalk

I have to check but I believe Bentley shows the location of that switch. Just need to see if there is room to test it. Sent from my iPhone...

Possibly. If there was room I’d try applying some voltage to the starter and see but there is no room to run a jumper cable up in there Sent...

It took some time to get all the heat shields off to get where I needed to be. I went back to the ECM and made sure I didn't bend or break any...

DME is good. No clicking. When I turn the ignition on dash lights come on and I can hear the fuel pump and what I think is the PS fan. I am...

I am getting power, dash lights, fuel pump comes on. There is power at the jumper bolt. I didn’t disconnect the starter so I didn’t check....

That did come to mind. Not sure what I would have pinched though. It was supposed to go in the shop tomorrow for an alignment but that ain’t...

Well I finally received the reset of my parts installed and buttoned up yesterday. Hooked up the battery no love. Had it tested today and the...

Got back under the mini replaced oil pan, oil filter, lower engine mount and crank sensor o ring. Fitted new outer tie rods and torqued down the...

Hope everyone had a great Thanksgiving. It’s been awhile since I have been on, but it’s been awhile since I have done anything with GIR too. A...

Great picture, reminds me of something you would see on Route 66. Sent from my iPhone using Tapatalk

I seem to remember reading a thread about someone fitting F56 seats in a R56, I think it was on the other site. I have done a little research and...

Washed and shined GIR yesterday so I could take him to a Marine Corps promotion ceremony today and took the long way home Sent from my iPhone...

Put the wheel arches and side skirts back on GIR after cleaning and refreshing them Sent from my iPhone using Tapatalk

Main reason I went to 17s, larger selection and definitely easier on the wallet. Sent from my iPhone using Tapatalk

320 AAA is pretty tacky - soft compound isn’t it? I run trough 500 AAA tIres on a l DD fairly quickly with a standard Mini alignment, a set a year.