Separate names with a comma.
No springs in that area that I have ever seen do you have a picture. Might want to take apart the pump and inspect it. If that thing locks up...
Torque center bolts first then work outwards. M8 x 35mm 30 Nm (22.1 ft-lb) M8 x 95mm stage 1 - 15 Nm (11 ft-lb) stage 2 - additional 90 degrees...
Well it's good you found the cause but damn I feel for you all that work has to be redone over a misprinted torque spec just sucks. At least you...
Joe Dirt
genius
wood
Aqualung
what spec did you use last time? if it was the 100deg spec you can reuse it as it was never stretched to the point of yield. But if you're...
Unfortunately no they don't interchange. Nor do the rotors or any of the brake stuff. There might be a possibility of changing out the whole...
The bolt or balancer would not have to move just the gear if the clamping force was not tight enough. Was your spec the 50nm and 180 degrees...
Found it. Cooper S (R56) L4-1.6L Turbo (N14) (2009) Engine, Cooling and Exhaust > Engine > Cylinder Block Assembly > Harmonic Balancer -...
That just sucks I have a manual at the shop I can double-check the torque process compared to all data for you Monday. Something slipped unless it...
Did you replace the sprocket bolts and crank bolt? They are torque to yield fasteners so they stretch when torqued some of that springs back when...
cool I have often wondered about the interchangeability of the various tritec engines and the latest e torq variant. That engine has roots back...
Oil samples with factory essso oil show changes needed at 15k the atp oil I have been running holds up better and 20k maybe a little more is ok....
I have done that when needed but better to get it clean from the start if you can dusting coats of clear as you said can bail you out as well but...
Service keep them serviced every 20k and they will last I service two other cvts one with 178k and one at 250k I really like the CVT it's...
I thought I did and I might I sent a pm to him. I know a few scotts that have minis and MINIS in bend. I think the Scott here had something to do...
one other thing I thought to add interior parts can be tough to get clean if armor all or other like treatments have ever been used the stuff will...
Also beware of contamination oils/water from the compressor I like to run one of the cheap little filters at the spray gun to catch anything that...