Separate names with a comma.
It warmed all the way up to 30* today so I started on the MINI thermostat project, it's amazingly difficult to get to all the hoses, clips and...
Yep..... [ATTACH]
5* out today - WAY too cold to work in the shop.....but it's supposed to be in the 50's by Monday, so everything will just have to wait a bit. I...
Yes, but I would have to pull the engine back out - well, it might be possible to do it in the car, but very difficult.... I'll just use my...
Well, a little more than yesterday....today I managed to take it for another spin around the block, a little farther this time.....my speedo is...
We have liftoff! [IMG] I drove it around the block today - it starts, shifts, stops (slowly - I need to bleed the brakes!) and does everything...
Well, it's a start.... :) VID 20220113 121155 - YouTube also, my buddy made me a plus sized cup holder.... [ATTACH]
I don't know if MiniFini is still in bidness, this was made for me by a friend - he 3D printed it to fit the seat mounts on a classic Mini
Well, she's ready to start, but even tho it was in the high 40's earlier today, by afternoon it had gotten cold again - headed down to the teens...
It's been a lot of work, but the results will be worth it if it turns out well.....
It already ran in the test stand, but it will be fun to hear it in the car and see it moving again....:cool:
Alrighty then, only 2 months after I tore it down - back on its wheels again......since the weather will be in the 40's tomorrow I'll put the...
Got the shop temp up to 50* this afternoon, so I got some more done on the Racing Green, got the "back" of the engine done and the radiator in,...
It's not hard to make them dry with the quality and variety of sealers available today. Plus clean parts and good gaskets do the trick. Now 10K...
The color choice (more of a cream than white) is because I was tired of all the usual colors - red, black, mowog green, yellow etc and I didn't...
I've done it with a cherry picker, but on these late model cars with the big brake booster you either have to remove that or tilt the engine at a...
The combination of the scissor lift and the hydraulic lift table make putting aa subby/engine back in from below a whole lot easier! She's in and...
Got a little more done.... [ATTACH] Undecided about installing starter, alternator and some other bits before putting it in the car, I know the...
Interior is all done, except for the seats. I'm going to hold off on those till the motor is in and buttoned up in case I have to get under the...
Why does it seem to take so much longer to put things back together than to take them apart? Interior going back together..... [ATTACH] [ATTACH]