Separate names with a comma.
I think... this is acommon repair. I bought a box of used brake ducting (hose type) from some Nascar team on eBay. Had tons of the stuff in lots...
I think that's what I used as well... But here's a hint. Measure the o-ring when you get a kit. Then you can buy a handfull of the suckers from...
See if Sneeds... will send you a couple inches of tube. Put it inside what you have to cover the hole. Get creative with fastening.... Or see...
another way to go... some al sheet, or plastic, and pop rivits. It's not high stress, so any of the above will work. I'd use whatever is easiet...
The difference is so dramatic I often wonder why the cars come with the camber settings asss-backwards! The best single thing MINI could do for...
Over the last few months, there have been some discussions about valvesprings, much without data or hard information. So anyway, I thought I'd...
And you call yourself a MINI guy... if you were a REAL MINI guy, you'd still own them all! ;) Matt ps, they all look so shiney! Mine only...
Well once you have the new one, you can tinker on the other one, find the source of the leak, clean it up and have it on the shelf.... Besides...
Calipers leak for two reasons. Bad seals and bad sealing surfaces. Usually if the leak persists through a rebuild, it's a ring groove or the like...
Nope.. I'm saying that 0.2 degrees is such a small difference most will never notice it. Just start somewhere, drive, see how you like it and...
I'm guessing... that the connector just wasn't well seated when the car was built and it took a while to come undone. at least it was a cheap...
Damn!!! No nice cheap 60 or 61 Falcons on eBay or Craigslist.... But I did find a 74 Fiat 124 Spyder that runs that I think I can get for...
I'm guessing... that they use the same mold with different plastic, but found that wasn't good enough and added the shield. But it's just...
Whenever I see one of these... on the street, I jones for it a bit.... I love the small size.... Would be a fun car and lots of Mustang parts...
you probably... won't notice any difference between -1.3 and -1.5 in the rear. And yes, getting the suspension up a notch from factory to...
Interesting indeed... so instead of different plastic like others have said that would be used, they just insulated the scoop with a heat shield!...
You'd be surprised the 1964 Ralley Falcon weighed less than 2200 lbs. And this was a bit bigger a car than the 60-63 model body that was raced...
Pulley is the first and best power adder for the SC'ed cars... do not pass go, do not collect $200... untill after you have a pulley. Matt
Laguna is well booked a long time out... it's hard to get good dates, it's a busy track. Matt
I just watched it again... there is no point where anything pulls away from it anywhere, there are one or two places where everyone holds the...