Separate names with a comma.
Several months ago I purchased and installed the AEM CAI that mounts an intake induction to the underside of the hood to make use of the...
I do see oil dripping out of both PCV hoses when disconnected, but none within the turbo housing. I've been using Royal Purple 5W-30 at intervals...
I don't understand where the turbo seals are located, but I doubt my turbo seals could be that bad with only 50,000 miles, what's your opinion on...
Could it be that during boost oil could be entering into the engine through the turbo inlet PCV piping?
Many years ago I owned a 87 Toyota GTS hatchback and I knew I was running lean so I measured the resistance of the O2 sensor and it showed that it...
A defective timing chain (rattle of death) does sound like it's coming from the passenger side of the engine bay if you're sitting in the drivers...
I hear this electrical tick on every cold startup then goes away after a few minutes. You're dead on accurate on where you say the sound is coming...
This has been an occasional issue since I purchased the car in March. Just to recap I've had the entire timing chain components replaced, then ECU...
An explanation has been given, but you seem to disagree with Dave and instead offer your suggestion (your own opinion) which is an assumption. Why...
Wow I'm glad I didn't purchase Finishing Solution at Dealing.com yesterday! I will buy some on Monday when I get back from Big Bear, thanks Dave.0!
I think you might be on to something Dave, before I replaced my head cover my cyclone separator must have been closed on one or both PCV ports...
I'm talking about the vinyl trim around the fenders, bumpers and runners. The C4 works best on hard plastic and not vinyl like where the wiper...
I have used the Gtechniq C4 on exterior trim around my MCS's body and it didn't last long, about three months. I've gone through two bottles of...
I was told by a competent mechanic that works on Mini's the the passenger side PCV tube is open during idle only, when you're under boost the...
I've been reluctant to install my BSH OCC because I'm worried about rising crankcase pressures when idling since the passenger side PCV ports...
Are the thermostats still made from plastic? No that plastic components belong in a cooling system!
Assuming it's a manual transmission could it be the sensor for the clutch pedal that perhaps doesn't think that the pedal is pushed in all the way?
These thermostat housings are a ticking time bomb, even after you replace it! Stupid Mini, what the hell were they thinking? Better yet they...
Thank everyone for replying, is the main pump located under the thermostat housing? If it is is it a good idea to replace the main pump as well?...
First of all I want to apologize for creating so many threads lately, but it seems I'm having a lot of problems lately. Timing chain components,...