Separate names with a comma.
Oh I forgot. 51 and ground should be 5 volts approx. is 4.89 V this is the reference voltage so looking at the Tmap diagram I think the reference...
Here's the electrical results. 27/2 and ground should be 3.9 V is 4.85 V ignition on engine off 31/4 and ground should be 4.0 V is zero...
It's possible the other Tmap is bad because the ECU was checked twice on an R50 so today I'm going to do the Bentley electrical tests and check...
I'm not cracking the Champagne just yet but today the engine ran for the first time since july without the misfire. As mentioned in...
Started this morning in positive mood, swapped the harness and crank sensor then fitted the ECU etc. went for a start and eventually the engine...
This thread has always been interesting!
Arm is on the mend so tomorrow looks good for the harness installation.
I don't smoke but I'm being driven to it! LOL everything looked better with alcohol! It's funny because my right arm looks like pop eyes arm !
raining every night so no time to work. Plus my arm has an infection from a cut I got last time I was here. On anti-biotic this week....no wine or...
My mistake on the knock sensor plug, it was the reverse light switch. I think this is an auto harness because the extra plugs are off the wires...
The fun begins again! I got here lunch time on Saturday but any thoughts of working on the Mini Sunday were over when my checked bag didn't show...
2:30am on the to the airport for round 4 of misfire mystery. I've already had interest from Hollywood for a movie lol.
At first I thought Mini Van as in Mini. But both were worth looking at. Thanks for sharing
Those VW diesels do well in rallies as do the Abarth 500....but to fly the flag(currently half mast) I'll stick with the Mini. I did think the...
The ECU guys just emailed me to say the key is on the way out! They sent me a video to show the EWS and key not communicating for a split second...
I have a volt meter which stays at a steady 14V and does not flicker when the fault kicks in. I've also run the engine with the knock sensor plug...
MCS02. ah yes there is a lot of reading for sure. I changed the timing chain and did a compression check which all looked fine. The misfire is...
Interesting and worth a look for sure. The BMW tech swapped all the wires around but each they did cross each other so I check next week. Thanks
Yes you are correct and I've emailed them on that point. Here's my positive thinking: When the CR dealer had the Mini they were going to work...
My worse fears came true! the ECU checked out fine. They sent me a video of my ECU on their donor Mini, they have the video showing the RPM at...