Separate names with a comma.
Note the dirty commutator on the armature; this prevents contact with the brushes.
Located within the door panels, four T-25 screws.
Wait to install the rear anti-sway bar. Springs are the first step, experiment with camber and tire pressure. I doubt you would see...
Is the smoke from under the hood or out the tail pipe? Did you fill the reservoir above the mid section on the cap's tube? First guess would be...
Feeder bands have been tracking over my place for two days, the nearby creek is higher than I've ever seen it, the sound of water cascading from...
Let's see if this link will work http://www.valeoservice.com/data/master/webfile/19835431504AD33F8566078.pdf?rnd=102 . The later model...
I normally would consider hot spots a sign of abuse, but in this case the flywheel was clearly defective.
Spark plug wire. Exhaust leak.
There are a some R53 builds where stock shaped springs would contact the inner wheel well body when increasing negative camber more than negative...
This bolt for the starter motor is located on the gear box side of the bell housing.
Here are lowering springs proven to work well on both street and track, plus they don't put the MINI on the bump stops all the time; just cut the...
Ireland engineering fixed camber plates.
Modular extensions, flat blade screwdriver, needle nose pliers, 13mm socket, 10mm socket, ratchets.
It depends on how much the springs lower the vehicle, but for most springs the arms have adequate adjustment range available. Another tip for...
http://www.motoringalliance.com/library/2nd-generation-mini-cooper-how-to-4/replace-springs-shocks-struts-68/
More visuals of fuel pressure variations; I have also seen a peak of 63psi while revving to 6k rpm. Pressure at idle: [img] Key on, cool...