Search Results

Marks where I would hack the tabs out

Here's a short chapter on how I managed to relocate the coolant reservoir. I am no metal worker as you can see. Some of you are probably laughing...

I have a turbo blanket for the exhaust housing, I'll take a pic when it gets light, do you think that will be sufficient? My OEM heat shield...

Here you can see the little filter through the fresh air port.

Intake assembly. I chose the Alta foam because I think they have good cell foam and I like foam anyway from running dirt bikes. Cleaning it is no...

I had to go mill around a silicon warehouse to find the right 1.375 to 1" reducer and coupler to make it work. Here's how they went together

The sensor would not fit into the silicon compressor intake from jmtc. As you can see it was the same diameter

Not much clearance from the valve cover with the new turbo

Jcw vs 47mm dominator

Jmtc has his own stamp which I thought was kind of cool

It's hard to compare with pics but i thought id share anyway

Manifold comparison

This is the little bracket no one mentioned in the write ups that made life easier. It's pointed to with the extension

One of the problem children... I had to pry against the manifold to get the clearance to get a wrench on the nut. That sucked. Anytime you...

The dominator

Exhaust side

Allllrighty, now I'll throw a dart at the wall and move on to the turbo and intake installation. There was nothing fun about installing the new...

Dee and Dennis on Welfare - It's Always Sunny in Philadelphia - YouTube

That pertplus dude was hilarious! I was thoroughly entertained from post #23 on I'll admit. What's the harm in a little flame? Little heat...

OBW, did you replace all 3 mounts or just the lower mount? (#5 in the diagram). I'll take your word for it that the BSH mounts are useless....