Separate names with a comma.
Maybe try to work some oil into that u-joint to try and get it to move smoothly again before you go to the trouble of removing the whole shaft?
Drop the subframe, it makes it oh so much easier and it's only a few extra bolts - plus, you can change the steering u-joint while you have it out...
No, it's Chevy Ecotec.....
Just to be sure, check your crank pulley, it has a rubber center than can fail......
Hey Bill, welcome to M/A, the fun and friendly Mini site! You just missed the joint event the St. Louis MINI club did with our KC Club...
Out of alignment generally will not cause a shimmy......any good tire shop should be able to get those tires smoothed out, but I've had a lot of...
Here's an interesting comparison.....10's, 12's and 13's...... [IMG] This photo makes my car look like a Countryman next to an R50!
I don't, I found it difficult to use when the SC is in the car, the one from Craven Speed is much more user friendly IMHO.
Ha! There's a big Army base there as well as the prison......Seth's in the Army.....
How do we get away with it? We're special!:biggrin5: I carry the Kansas plate in the car, I'm thinking about buying a magnet like the dealers...
Seth took my 10" wheels up to Leavenworth to have a buddy of his balance them, I haven't gotten them back yet so I'll do the drive this weekend on...
for both Buzz and another club member's car.... Our KC Club is doing a Donut 66 Run tomorrow, down to Joplin and across Rt 66 into Kansas and...
Yes! They are about 2 months overdue at this point......I needs me some Project Binky!
Turned out the Victoria British parts were correct - exactly the same as on a Spridget - and I got everything cleaned up and put back together...
No he's rght, Pre-A blocks are like that too - mine is.
I got Buzz all re-assembled this afternoon and took him for a quick spin around the block - he started right up and ran perfectly and all the...
Yep, I was surprised to see my engine did not have tappet covers - my 62 1100 had them..... It probably is leaking from the fuel pump gasket,...
"I see" said the blind carpenter, as he picked up his hammer............and saw.
Wayne Carrini has a red Twini.....
I always had good luck with the OEM cork gaskets - I'd glue it on the valve cover, then put a good coat of grease on the other side, so I could...