Separate names with a comma.
After extreme lowering like that you could use a control arm with extra adjustability like one from Eibach’s rear alignment kit; the arms look...
SP Crossdrilled Brake Rotors SOLD Drilled front and rear SP rotor pairs for First Gen MINIs, $210 plus shipping. Drilled rotors look great...
The Quaife is a Torsen (gear driven) type ATB, no need for friction modifiers. A clutch plate type LSD (like OE MINI's) can require modifiers to...
The bolt in question is a single use, torque-to-yield bolt. Use a new bolt for the install; tighten to 41 ft-lb and a torque angle of 90 degrees....
I know when the strut reaches a pro; it will get the scrutiny it requires. In the mean time, if roach13 did not perform the strut install and/or...
I have not read where you replaced the aftermarket plug wires with NEW (not almost new) OEM plug wires yet (#1 possibility in my opinion), or...
The camshaft on the right has been re-ground by Crower to a performance profile.
PTFE (Teflon) coating on my Crower/NitroStick re-grind camshaft and rocker rails before install.
That's a niffty case, I would like to have the bracket tool for something else, but if you must lift the motor to put the support bracket on you...
At 106000 miles I've gone full circle on most motor modifications (at least those that can be seen).
One advantage the PowerGrids have over a traditional Hiem joint (Alta style) is range of motion on the ends. The OEM link ends are the overall...
For a MINI that has been lowered 1.5 inch or more, the front OE drop links are put at a disadvantage, at the least they knock, or at the extreme,...
Way off topic:lol:, I'll take the reply to P.M.:smilewinkgrin:
I have opinions based on anecdotal evidence to share. From my Internet research, conversations with a couple lube manufacturers, and Terry Dyson,...
Our gearbox has an OE internal magnet in a slot not far from the drain plug; it is about the size of a half dollar. Looking at the case half in...
Mine is North of 100k; it's better than ever on many levels. The driver's seat has finally broken in and fits just right.:D
Yes, all new MINIs have slotted trailing arm bushing brackets for adjusting toe (that’s why there is a small door below the skirt to fit a 16mm...
Camber can be adjusted using either upper or lower rear control arms; it is more convenient to adjust using the lowers. Toe adjustment should be...
I’ve done this job more than a few times and highly recommend using the OEM locking tool and OEM bolt, but I anticipate the question of “can the...
I doubt the front spring seat coil will fit the lower spring perch of an OE strut.