Most liked posts in thread: Antenna Base Moulding

  1. INAMINI

    INAMINI New Member

    Mar 5, 2012
    8
    1
    0
    Washington State
    Ratings:
    +1 / 0 / -0
    #8 INAMINI, Mar 6, 2012
  2. Crashton

    Crashton Club Coordinator

    Jun 4, 2009
    19,445
    10,057
    113
    Retired old fart
    Hooterville Ohio USA
    Ratings:
    +11,698 / 2 / -0
    #2 Crashton, Sep 18, 2011
    I think you need to start searching wrecking yards. Unfortunately lots of parts are only available as complete assemblies.

    Welcome to M/A... :)
     
  3. Justa Jim

    Justa Jim Well-Known Member
    Lifetime Supporter

    May 6, 2009
    7,422
    1,685
    113
    Ratings:
    +1,685 / 0 / -0
    #3 Justa Jim, Sep 18, 2011
    Welcome to the site. Somebody out there might have one for sale. :Thumbsup:

    Jim
     
  4. kmwatersaz

    kmwatersaz New Member

    Nov 9, 2010
    2
    0
    0
    Ratings:
    +0 / 0 / -0
    #4 kmwatersaz, Sep 19, 2011
    Thanks for the ideas but this is way too simple to require a yard search for an entire base. Think I'll start with some double sided tape and maybe a thin strip of heat shrink. I am also thinking about cutting a rubber strip of windshield wiper and trying that out with some super glue or silicone caulk.
     
  5. Nathan

    Nathan Founder

    Mar 30, 2009
    25,144
    10,052
    113
    Writer
    Short North
    Ratings:
    +10,069 / 0 / -0
    #5 Nathan, Sep 19, 2011
    Might want to check with some of the site sponsors to see if they have one. Some of them such as Detroit Tuned and Way Motor Works often buy totaled MINI's and have a good selection of used parts on hand.
     
  6. Crashton

    Crashton Club Coordinator

    Jun 4, 2009
    19,445
    10,057
    113
    Retired old fart
    Hooterville Ohio USA
    Ratings:
    +11,698 / 2 / -0
    #6 Crashton, Sep 19, 2011
    ^ Good idea....
     
  7. Detroit Tuned

    Detroit Tuned Well-Known Member
    Motoring Alliance Founding Sponsor

    May 5, 2009
    301
    319
    63
    evertyhing
    Metro Detroit
    Ratings:
    +319 / 0 / -0
    #7 Detroit Tuned, Sep 26, 2011
    The molding is part of the base. you would have to have a whole base to replace it.
     
  8. Nathan

    Nathan Founder

    Mar 30, 2009
    25,144
    10,052
    113
    Writer
    Short North
    Ratings:
    +10,069 / 0 / -0
    #9 Nathan, Mar 6, 2012
    RealOEM.com is a great source to look up parts.

    Then when ready to purchase the fine Motoring Alliance sponsors are ready to help you too.