I have the ACT flywheel, but at the time that I bought mine, the pressure plate and disk were not avail.
Nonetheless, I can give you my opinion on that.
The flywheel is a really good piece. I recommend it to replace a worn out dual mass unit.
They are 2lbs heavier than their aluminum counterparts. ~13.5lbs (i think)
Solid steel - no replaceable inserts.
Engine revs are much quicker and engagement is much, much better. (read, better feel)
You mentioned the rattle/chatter... mine did it right off.
However, I have replaced other cars' flywheels with this one, and they didn't.
I think it depends on your trans., cosmic alignment, etc.
And i'll add that I have installed numerous ACT disk and PP combos and have never had a complaint.
-
-
I've had mine in for two years with no problems.
The flywheel while it doesn't have a replace able insert it can be resurfaced. So it is reusable. Mine doesn't chatter I used redline lightweight shockproof oil in the trans.
I would recommend it. -
Thanks guys.
I think i will give it a shot
-Jonathan