Exterior 2nd Gen Most liked posts in thread: Cold Exterior Trim Blackout

I've used Plastidip quite a bit. The secret to getting it to flow for a smooth finish is to keep it warm while using. I accomplish this by putting the can in hot water and returning it to the hot water between coats. I personally would not coat anything in temps below 50 degrees or when the substrate is colder than 50 degrees.

 

I've never used plasti dip myself but was curious and I found that others have used the product in the 40's with very good results. The consensus was to keep the can warm between coats was more important than outside temps. Like I mentioned I have no personal experience with the product I just googled because of curiosity.

 

I've only used it in warm weather. But as thick as it is I would think that you could end up with a very textured finish.

When I did my gas filler door I heated the part to get the best adhesion.