Exterior 2nd Gen Most liked posts in thread: DIY Driving Lights Project

Needs German Washer Fluid

Amazon.com: einszett 921008 Kristall Klar Washer Fluid Concentrate - 8.5 fl. oz.: Automotive

 

Just for the record, how much has this project cost so far? Minus your time of course.

 

Even at a dollar an hour this is not a cheap mod Jim. :wink:

I'd love for Chuck to craft some mods for my car, but no $$$$ for the job.

 

You are very right on that...

 

Fondled these lights today. Once done there are going to be wonderful. The project is moving along smartly. When the weather gets warmer I predict they will be done asap!

 

I did a similar thing on Buzz for the high beams in the Hellas, since I went with the 100W bulbs, I didn't want that much power being pulled thru the highbeam switch and melting it.....where do you get water proof relays?

 

Nice work MM it's only been a year so far. :lol:

Engineering perfection takes time. opcorn:

Are you going to show these off at the Dragon?

 

You went during the off season, both times.

 

But nobody was there except you and a small group from NC. MOTD was long over, which is why you didn't see me, or Nathan, or Crash, or Mark or........the list goes on and on.

 

Well we have a dedicated DONUT run. :donut1:

Hope you make it down this year.

 

As long as we don't run out of my medicated donuts I'm OK..... It's a short push to the edge for me. :crazy:

 

Are we sure about this? I mean Dave.0 says he is at the dragon every year, but no one has ever seen him!!

Maybe metalman is in stealth mode whilst he is there.......

 

I have seen the elusive Dave O. at the Dragon for the past two years. Wonder if I will spot him there this year. (Donut run) Yes I am sure I will

 

That's just pure art, great work MM.

 

Make sure to use high quality wire nuts for your harness. I think I have some left over romex wire if you need it. :wink: