It just sold for $550 shipped on eBay! Thanks for looking
Page 2 of 3
-
-
-
-
-
-
-
If you are in a warm part of the country leave your car in the sun for a few hours.
Next get some fine wire because fishing line will break too easy and the spoiler is only glued on if its the JCW one above for sale.
The OEM stock NON JCW one has one bolt at each end and is also held in place by strong double sided tape.
((Make sure you wear leather gloves because the wire or Fishing line will cut your hands))
Grip both ends of the wire and slide it under one side of the spoiler and slowly saw (using the wire) to cut between the glue.
It will take time and if its cold where you live you may want do this in a heated garage and use a heat gun to warm the wire to make cutting the glue easier. Do not heat the spoiler because it will melt.
Slow and easy is the trick.
It would not hurt to put a layer or two of painters tape around the edges so you do not scratch your roof with the wire while sawing.
Hope this helps you out. -
Metalman. i want to get it off so that somebody that wants it could have it and not break my back door! haha but good job!
-
Where are you located? If you need help.
Also if it's a Silver one I may also have your buyer. (not me) I have one in Black already.
-
-
-
Savvy, it's easy to paint. You're up buddy, open your wallet. :lol:
-
-
-
-
-
-
Page 2 of 3