nm Engineering intake - like new - PENDING PAYMENT nm Engineering Hi-Flow Induction Kit -- was $260 new; if it wasn't listed as "used" you'd never know, it's that clean. basically installed and removed. all parts included in original box The "Open-Air-Box" system gives you an abundance of unrestricted 360 degree air source compared to the OEM's sealed air box with a flat filter and tube fed air source. During R&D, NM installed temperature probes around the engine compartment and the gauge showed the inside temperature matched the ambient after vehicle speed past 20 mph. Logging the Mass Air Flow (MAF) sensor also showed that the open-air-box intake generated higher volume (gr/sec) of air going through the sensor. So when NM had to choose between (a) cooler air at all speeds with limited air source, vs. (b) cooler air at 20~ mph. with unlimited air source, the choice was pretty obvious. Also included is a pre-oiled and cleanable NM filter. This kit fits US & Canada MCS with N18 engine (2011~12) as well as older model with N14 engine (2007~2010). Fitment: R55 MCS & JCW Clubman 2011+ R56 MCS & JCW Hardtop 2011+ R57 MCS & JCW Convertible 2011+ R60 Countryman 2011+ *see note at nm Engineering website regarding vehicles manufacturer after 4/12 NM Eng. Hi-Flow Intake Kit Asking $215 and $18 shipping or meet up and spare the shipping cost (next month: Blue Ridge Parkway, The Great Ice Cream Run - lots of places to cross paths!)