MSD is the same way. I swung by ACE hardware and bought some fancy flange headed bolts. 6mm I think? I also used the OEM rubber "washer" between the coil and the engine, not sure if it matters.
-
-
Mr. Jim MudsharkLifetime Supporter
The sleeves will come off the oem bolts, as I used the ones that came with the MSD kit but since they had no fixed washer-head the oem rubber vibration washers spugged out. I used the oem ones without the collars and used thick o rings for the vibration dampers.
-
how do you get the sleeves off the bolts?
-
Another way might be?
6mm Stainless Steel (SS) thread stock,nylon bushing to raise coil up allow for air under coil SS flat washers and SS cap nuts.
-
-
Mr. Jim MudsharkLifetime Supporter
I do like that other idea also, very nice.