Getting closer on finishing up the Mini for MOTD...Engine all buttoned up, exhaust installed, and since I was running a bit ahead of schedule I ordered in a new fuel filter and a set of Red Stuff front pads (only 1/3 left on the current pads, and since everything was apart anyway...)
This weekend I'll get the fuel filter in and with a bit of luck clean and install the set of leather seats I picked up a few months back....after that it's time to drop her off the jack stands and fire things up!
(And the Mrs is most relieved that I got it all back together without any left over parts sitting in the bin!)
Page 3 of 3
-
-
OOF, just found out I need to do
- Tensioner (weeping cylinder), and while in there going to do the idler pulley & belt
- Trans oil change to Redline MTL
- Exhaust modification to reduce below-shifter heat (and change the tone some)
- Replace shifter box bottom that I melted last year, probably should replace the one I fabbed from an old beer keg to get me by!
- Maybe take off and sell the fixed camber plates in advance of fabbing new ones...
And all in the next few days! -
-
Oh yeah... wash and wax... yeah...
-
Stinker Active Member
-
Dave.0 Helix & RMW PoweredLifetime Supporter
No rain after I show up at Fontana Monday.
Now Saturday night, for some reason, it always rains. -
wmwny Well-Known Member
Looks like a wet and wild week coming up, unfortunately. For sure, I'm packing raingear.
-
-
Mr. Jim MudsharkLifetime Supporter
That event was last Saturday at Hendrick...
Page 3 of 3