Most liked posts in thread: ScanGauge mount for MINI

Looks good, but still have to mount it somewhere.

 

Scan Gauge Mount

Mine has it's velcro on each end. It's at the same place, but it's velcro'd to the steering collumn and the end of the dash on the left of the steering wheel. It sits higher than yours does, directly in front of the dash insert. In this position it can be angled in any position that one prefers. The wire of course, goes beside the steering column,into the dash and from there to the OBDII. Jason

 

Just so you know....

a custom injection mold is on the order of $2k via China, about $4k if you do it here in the US. Doing the two tone requires some painting or fancier plastic work, so the costs go up, and this is before you sell the first unit. The other way to go would be to CNC some Aluminum and paint, this has a lower set up cost but a higher unit price.

Matt

 

I don't know. I think with the Craven mount it looks very nice :cornut:

 

The rounded mount is a neat look but I'm not sure the market justifies the production costs. One could always try and make this for themselves though.
Mine is mounted by the windshield in the front left of the dash and is very easy to glance at while driving. This location does have the disadvantage of being bleached out by bright sunlight though.

 

You just gave me an idea as I have an extra rear center console piece out of an earlier R53 sitting around I could hack to bits.