Interior 1st Gen Most liked posts in thread: Speedometer trim rings

Welcome, thanks for joining Motoring Alliance, the FUN and Friendly MINI Community.

That youtube from the electronics place in Cali is probably the one by rkw.

Might want to send him a private message through the site pointing out this thread to him.

 

I've never made a YouTube video for this.

Try the instructions here (post #66): http://www.motoringalliance.com/forums/interior/2773-dash-dissasmbly-how-2.html#post25386
Also look at the rest of that thread for more information.

To give you a point of reference, the center dash panel is one piece (black and painted sections together), and the speedo ring snaps onto it by friction fit. I have pictures of the speedo ring itself in my gallery: http://www.motoringalliance.com/gallery/showgallery.php/cat/586



I've heard someone say that they had a chrome speedo ring and it was glued on. If the ring doesn't simply pull off, you'll have to remove the center dash panel piece.

 

I thought once you had all that kinda loose that the big ring would rotate/spin off. Do know that with the factory cup holder sitting up that high that if you get a drink to splashing around it ends up right under that ring on the little shelf like area and will make it hard to rotate/spin..

 

Yes you do need to pull the center dash section to remove the big ring. There are a few clips that need pulled up all at the same time to get it loose.

Funny I found this thread, I am pulling all my trim tomorrow, and getting it ready for paint. Not for me though, they will be mailed out and swapped for genuine chromeline pieces.