Most liked posts in thread: Thinking of getting new wheels

If I remember correctly mine were made by Circuit. It important to make sure the measurements they list are the ones you need. Close is not going to fit.


Sent from my iPhone using Tapatalk

 

I had the same issue when I bought new wheels. They do sell center bore adapters to fill in that space you mention, you would have to verify required size.
Some wheel and tire sites have fitment calculators that will give you a visual representation of how the wheel will look adjusting wheel and tire measurements. Not the one I used but this one should give you an idea of the setup you have now compared to the new one. Not perfect but it should give you an idea of what you are looking at.

https://n4sm.com/wheel-offset-calculator

 

Correct. Just a suggestion, I would stick with the metal type, didn’t see to many good comments about the plastic ones.


Sent from my iPhone using Tapatalk

 

I didn't see pictures of rims, where are they?

 

You have to look them up yourself

 

Thanks, they look nice. Though, I prefer a wheel that has the center section set in from the edge of the wheel, So there is a little ledge. Bringing the spokes right to the edge of the wheel just grates on me.