Please post up your experience / review with the metal cross over pipe...
I've been eyeing that piece for a while...
Page 1049 of 1057
-
Metalman Well-Known MemberLifetime Supporter
- Sep 29, 2009
- 7,689
- Ex-Owner (Retired) of a custom metal fab company.
- Ratings:
- +7,961 / 1 / -0
-
There are two places on the pant down low where you can almost see a little bondo. It’s very thin. Maybe one day I will have it resprayed but for now it looks good. Besides after all I had to do to the Lotus my wife has advised me I will not touch this car, no modes. I have tried to reason with her that duel Webers are better than FI but she just threatens to take all my tools away from me.
I am a little afraid of her!-
Funny x 2
- List
-
-
checkers Well-Known Member
Living in California we go every 2 years. It's a pain. Mainly because all the mods have to be EAP approved. The shop I use to use it was not a problem , but the last time at a new shop they went over it top and bottom. They even put it on a rack to check under it. I had to change the header. The part that bugs me is it always passes the tail pipe test but not the visual test. I don't understand if it passes the tail pipe test who cares what it looks like.
-
Agree x 3
- List
-
-
They should just put the sensor up the tail pipe. If it is in the correct range that should be it. Why does it matter if my car is modded if it is not putting out anymore pollution then if it were stock. My heavily modded Exige is at lambda 1 when I am at an even speed.
It’s about control.-
Agree x 4
- List
-
-
checkers Well-Known Member
Page 1049 of 1057